This is a SpadNext profile for the XTouch Mini focused on the G1000.
Main Autopilot modes - COM+NAV 1-2 - PFD+MFD Menus and Knobs
LEDS will light on when selected modes are active + some little extras
ONLY Layer A is used = plenty of room for you to keep on customizing on Layer B
ENJOY and I will appreciate feedback if you wish some improvements
Any reccomendations for getting the overlay printed to put on the physical controller?
2 years ago
a pixel converter says that 32cm = 1210 pixels. So resizing the length to 1210 pixels should do the trick. I then stapled the layer in a cut plastic sleeve (best are the more rigid ones). Hope it helps.
2 years ago
Nokeel
JstnJ